Setting up Utility Warehouse Router for VoIP First step is to ensure you have all the connection setting for the VoIP service. Typical settings are shown in the table on the right. Example VoIP Server: phone1.V0ip.uk account number: AB123456 account password: abcd1234 Telephone number: 01234 567890 Login to the UW router as admin and click on 'Telephony' (translated from chinese) enable and then the gear wheel to get to settings. Fill in the the VoIP server settings for both primary register and primary proxy port, then click the tick on the right hand side to save the settings. Next click on the Phone number tab. Click on the enable slider on the left and fill in the account name and password. URI is left blank, display name is the CLI and will usually be the traditional phone number this time click on the save button at the bottom of the window when it shows, then close. There are 3 profiles: Profile 0 : this will combine both telephone sockets to the same account. Profile 1 : The will link telephone socket 1 only to an account. Profile 2 : This will link telephone socket 2 only to a different account. If all is correct there should be a green dot next to the 'Telephony' Enabled. You may need to reboot the router. Once you have this working you can adjust other settings under the in/out mapping, Ringing Schedule, etc. to fine tune your setup.